Vehicle Electrical System Control Module J519 Bracket, Replacing; Parking Aid Control Module J446 / Parallel Parking Assistance Control Module J791 Bracket, Removing And Installing; Parking Aid Control Module J446 / Parallel Parking As- Sistance Control Module J791 Bracket, Removing And Installing - Volkswagen Golf 2015 Repair Manual

Golf 2015 ➤ , Golf Variant 2015 ➤
Electrical Equipment - Edition 12.2015
– Remove the bolts -2, 3, and 6-.
– Push the bracket -1- as far as possible out of the central tube
until the alignment pins -4- and -5- are disengaged.
– Cut the cable ties -arrows-.
– Free up the wiring harness on the mount.
– Remove the bracket to the vehicle interior.
Installing
Install in reverse order of removal.
Tightening Specifications
Component
Bracket for Vehicle Electrical
System Control Module - J519-
to central tube
2.7 Vehicle Electrical System Control Mod‐
ule - J519- Bracket, Replacing
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
– Remove the Vehicle Electrical System Control Module - J519-
bracket. Refer to
⇒ "2.6 Vehicle Electrical System Control Module J519 Brack‐
et, Removing and Installing", page 301
– Remove the Vehicle Electrical System Control Module -
J519- . Refer to
⇒ "2.4 Vehicle Electrical System Control Module J519 , Re‐
moving and Installing", page 299
– Remove the Parking Aid Control Module - J446- / Parallel
Parking Assistance Control Module - J791- . Refer to
⇒ "9.2 Parking Aid Control Module J446 , Removing and In‐
stalling", page 200 .
– Remove the Front Parking Aid Warning Buzzer - H22- . Refer
to
⇒ "9.3 Front Parking Aid Warning Buzzer H22 , Removing and
Installing", page 201
Installing
Install in reverse order of removal.
2.8 Parking Aid Control Module - J446- /
Parallel Parking Assistance Control
Module - J791- Bracket, Removing and
Installing
Special tools and workshop equipment required
♦ Feeler Gauge
Removing
– Turn off the ignition and all electrical equipment.
– Remove the ignition key, if equipped.
302
Rep. Gr.97 - Wiring
Tightening Specification
4.5 Nm
.
.
.