Regulations And Standards; Conformance To Eu Directives - Omron NY Series Hardware User Manual

Regulations and Standards

Conformance to EU Directives

The IPC Programmable Multi Axis Controller complies with EU Directives. To ensure that the machine
or device in which the IPC Programmable Multi Axis Controller is used complies with EU Directives,
the following precautions must be observed:
• The IPC Programmable Multi Axis Controller must be installed within a control panel.
• The IPC Programmable Multi Axis Controller that complies with EU Directives also conforms to the
Common Emission Standard. Radiated emission characteristics (10-m regulations) may vary de-
pending on the configuration of the control panel used, other devices connected to the control panel,
wiring, and other conditions. You must therefore confirm that the overall machine or equipment in
which the IPC Programmable Multi Axis Controller is used complies with EU Directives.
• This is a Class A product (for industrial environments). In a residential environment, it may cause
radio interference. If radio interference occurs, the user may be required to take appropriate meas-
ures.
Applicable Directive
EMC Directive
EMC Directive
OMRON devices that comply with EU Directives also conform to the related EMC standards so that
they can be more easily built into other devices or the overall machine. The actual products have been
checked for conformity to EMC standards.
Applicable EMC (Electromagnetic Compatibility) standards are as follows:
• EMS (Electromagnetic Susceptibility): EN 61131-2
• EMI (Electromagnetic Interference): EN 61131-2 (Radiated emission: 10-m regulations)
Whether the products conform to the standards in the system used by the customer, however, must be
checked by the customer. EMC-related performance of the OMRON devices that comply with EU Di-
rectives will vary depending on the configuration, wiring, and other conditions of the equipment or con-
trol panel on which the OMRON devices are installed. The customer must, therefore, perform the final
check to confirm that devices and the overall machine conform to EMC standards.
NY-series IPC Programmable Multi Axis Controller Hardware User's Manual (W580)
Regulations and Standards
23