HP Converged Architecture 700 Deployment Manual page 49

Set Up VMkernel Ports and Virtual Switches
a Change the network label to VMkernel-MGMT and select the Management Traffic checkbox:
• If the <<mgmt_net_vlan>> is 1 or untagged, ensure that the VLAN is set to 0 (None).
• If the <<mgmt_net_vlan>> has a value other than 1 or untagged, set <<mgmt_net_vlan>> as the
VLAN ID and click OK.
b Click OK to finalize the edits for the management network.
5 Select the VM Network configuration and click Edit:
a Change the network label to Management:
• If the <<mgmt_net_vlan>> is 1 or untagged, ensure that the VLAN is set to 0 (None).
• If the <<mgmt_net_vlan>> has a value other than 1 or untagged, set <<mgmt_net_vlan>> as the
VLAN ID and click OK.
b Click OK to finalize the edits for the management port group.
6 Optional: If using a separate network as a deployment network (not running deployment over Management),
click Add to add a network element:
a Select Virtual Machine and click Next.
b Change the network label to Deployment.
Do not specify a VLAN ID because the deployment network must be a native VLAN.
c Click Next and then Finish to finalize the creation of the Deployment network.
7 To add the vMotion network, click Add to add a network element:
a Select VMkernel and click Next.
b Change the network label to VMkernel-vMotion and enter <<mgmt_vmotion_net_vlan>> in the
VLAN ID (Optional) field.
c Select the Use This Port Group for vMotion checkbox.
d Click Next to continue with vMotion VMkernel creation.
e Enter the vMotion IP address <<mgmt_server_1_vmotion_ip>> and subnet mask
<<mgmt_vmotion_net_netmask>> for the host.
f Click Next and Finish to finalize the creation of the vMotion VMkernel interface.
8 Select the VMkernel-vMotion configuration and click Edit:
a Change the MTU to 9000.
b Click OK to finalize the edits for the VMkernel-vMotion network.
9 To add the Fault Tolerant network, click Add to add a network element:
a Select VMkernel and click Next.
b Change the network label to VMkernel-FT and enter <<mgmt_ft_net_vlan>> in the VLAN ID (Optional)
field.
c Select the Use This Port Group for Fault Tolerance Logging checkbox.
d Click Next to continue with vMotion VMkernel creation.
e Enter the vMotion IP address <<mgmt_server_1_ft_ip>> and subnet mask <<mgmt_ft_net_netmask>>
for the host.
f Click Next and Finish to finalize the creation of the VMkernel-FT interface.
10 Select the VMkernel-FT configuration and click Edit:
a Change the MTU to 9000.
b Click OK to finalize the edits for the VMkernel-FT network.
11 Close the dialog box to finalize the ESXi host networking setup.
12 Repeat this procedure for the other management servers in the configuration.
©
Copyright 2017 by Nimble Storage, Inc. All rights reserved.
Documentation Feedback
49