Removing The Cd Changer Unit - JVC MX-J170V Service Manual

MX-J170V

Removing the CD changer unit

Prior to performing the following procedure, remove
the top cover, the side covers and the CD Tray
fitting.
1. Disconnect the card wire from connector SCW1 of
the CD servo board on the back of the CD changer
unit.
2. Disconnect the harness from connector FW2 on the
inner side of the main board in the body.
3. Disconnect the harness from connector VCW2 on
the VDC power board .
4. Remove the two screws C attaching the CD changer
unit on the back of the body.
5. Draw the CD changer unit upward from behind while
pulling the rear panel outward.
1-8
(See Fig.11 to 13)
CD servo board
SCW1
CD changer unit
Main board
Rear panel
Front panel assembly
CD changer unit
VCD power board
FW2 VCW2
Fig.11
C
Fig.12
Rear panel
VCD power board
Fig.13