Putting On The Heart Rate Monitor - Mio Cyclo 400 series User Manual

• Cadence sensor
1 2
2. When done, you can manually pair the sensor with your device
by tapping Main menu > Settings > Sensors > Speed sensor /
Cadence sensor.
The speed/cadence sensor contains a replaceable CR2032 battery.
Follow the instructions below to replace the battery:
1. Locate the battery cover on the back of the sensor, and then twist the
cover anticlockwise (e.g. by using a coin) to remove the cover and
battery.
2. Insert the new battery into the battery chamber and replace the cover.
3. Twist the cover clockwise (e.g. by using a coin) to close the cover.

Putting on the heart rate monitor

Note: Please note the heart rate monitor is not a medical device and its readings are
not a substitute for obtaining measurements that require medical precision. It is strongly
recommended to consult a doctor if you have a pacemaker or other implemented
devices before using the heart rate monitor.
3 4
1. Before using the heart rate monitor, wet the contacts on the back of
the chest strap.
Note: If possible, you can also use an electrolyte gel (usually available in local
sports stores) to ensure good contact.
2. Adjust the elastic strap so it's snug while you are putting it on. Ensure
that you can take a good deep breath after putting on the strap.
3. Follow the instructions below to wrap the strap around your back, and
then secure it on the other side with the buckle.
Putting on the heart rate monitor is like wearing a belt around your
lower chest.
4. When done, you can manually pair the monitor with your device by
tapping Main menu > Settings > Sensors > Heart rate.
The heart rate monitor contains a replaceable CR2032 battery. Follow
the instructions below to replace the battery:
8