Yamaha RX-V2065 Service Manual page 29

6. When writing of the firmware is completed, "Vx61 DSP Flash finished!" is displayed. (Fig. 3)
7. Click [EXIT] to end DSP_FLASHER_v2.7.exe. (Fig. 8)
8. Start up the self-diagnostic function and select "25.ROM VER/SUM/PORT" menu.
Using the sub-menu, have the firmware version and checksum displayed, and then check that they are the same as
written ones.
*
When the firmware version and checksum are different from written ones, perform the "Writing to DSP" all over
again.
9. Press the "MAIN ZONE ON/OFF" key of this unit to turn off the power.
10. Disconnect the power cable of this unit from the AC outlet.
11. Remove the RS232C conversion adaptor and flexible flat cable from the writing port (CB27, DIGITAL P.C.B.) of this
unit.
Fig. 8
RX-V2065/HTR-6295
29