Supplementary information:
In this unit, it is possible to check the firmware version by using the ADVANCED SETUP menu as well as the self-
diagnostic function menu.
Follow the procedures below.
1. While pressing the "STRAIGHT" key of this unit, press the "MAIN ZONE ON/OFF" key of this unit to turn on the
power.
The ADVANCED SETUP mode is activated, and "ADVANCED SETUP" is displayed. (Fig. 1)
2. Rotate the "PROGRAM" knob and select the "VER---.---.---". (Fig. 1)
After a few seconds, each firmware version is displayed.
T model
U, C, R, K, A, B, G, E, F, L models
ADVANCED SETUP mode
A D V A N C E D S E T U P
3. Press the "MAIN ZONE ON/OFF" key of this unit to turn off the power.
"MAIN ZONE ON/OFF" key
After a few seconds
Firmware version
V E R - - - . - - - . - - -
Fig. 1
"PROGRAM" knob
"STRAIGHT" key
V E R 0 2 4 . 1 0 3 . 0 1 9
BF (Sub-microprocessor) version.
TI (DSP) version.
Main microprocessor version.
Note) The checksum is not displayed.
RX-V2065/HTR-6295
21