Figure 2-9. Expander To Computer Attaching Screws - HP 330 Service Information Manual

Figure 2-9. Expander to Computer Attaching Screws
b. Remove the expander from the computer and install the connector's protective
sleeve or set the expander on its side.
c. Remove the flat-head screw that holds the computer's top cover to the motherboard
connector.
2. Slide the computer's top cover to the rear and lift up on the back of the cover to remove
it.
3. To install the top cover, place the top cover on the chassis, ensuring the RF shield plates
are outside the sides of the chassis.
Assembly Note
When installing the top cover, ensure the lip on the back edge of the
top cover catches the tab on the chassis when the top cover is fully
seated in place.
4. Slide the top cover forward and fit the front of the top cover inside the front cover edges
and engage the lip on both sides at the rear of the cover in the tabs on the chassis.
5. If an expander is to be installed:
a. Replace the top cover screw.
b. Install the expander.
c. Replace the two expander attaching screws.
d. Replace the expander top cover.
42
Assembly Replacement