Hdmi; Xm Radio Messages - Pioneer VSX-1016TXV-K Operating Instructions Manual

Additional information

HDMI

Symptom
No picture or sound.
No picture.
OSD does not appear.
No sound, or sound suddenly
ceases.

XM radio messages

Symptom Cause
Check Antenna
The XM antenna is not connected.
XM ANT ERR A short-circuit occurring in the antenna or
surrounding antenna cable.
Updating The radio is being updated with the latest
encryption code.
No Signal
The XM signal is too weak at the current location. n/a
Loading The receiver is acquiring audio or program
information.
Off Air The channel currently selected has stopped
broadcasting.
CH– – – You have selected a channel that does not exist,
or that you have not subscribed to.
– – – – – – – – There is no artist name/feature, song/program
title, or channel category associated with the
channel at this time.
Note
• If the unit does not operate normally due to external effects such as static electricity disconnect the power plug
from the outlet and insert again to return to normal operating conditions.
Remedy
• If the problem still persists when connecting your HDMI component directly to your monitor, please
consult the component or monitor manual or contact the manufacturer for support.
• Depending in the output settings of the source component, it may be outputting a video format that can't
be displayed. Change the output settings of the source, or connect using the component, S-video or
composite jacks.
• The OSD will not appear if you have connected using the HDMI output to your TV. Use component, S-
video, or composite connections when setting up the system.
• Since the HDMI audio signal is sent through this receiver to your TV, you need to make separate
connections for audio if you want to hear your HDMI component through this system. See Connecting using
HDMI on page 41 for more on this.
• If you've made separate connections for audio, make sure you have assigned the analog/digital jack(s) to
the corresponding HDMI input for the component. See Assigning the HDMI inputs on page 47 to do this.
• Check the audio output settings of the source component.
Action
Check that the XM antenna cable is attached securely.
Make sure that there is nothing unusual with the antenna or
antenna cable. Switch the power off then back on again.
Wait until the encryption code has been updated. Channels
00 and 01 should function normally.
Wait until the information has been received.
Select another channel.
The receiver will automatically switch to channel 001 (or the
last selected channel).
No action needed.
12
61
En