Using The Sleep Timer; Dimming The Display; Switching The Speaker Impedance; Resetting The System - Pioneer VSX-1016TXV-K Operating Instructions Manual

Using other functions
10

Using the sleep timer

The sleep timer switches the receiver into standby after a
specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use
the remote control to set the sleep timer.
• Press RECEIVER then press SLEEP repeatedly to set
the sleep time.
• You can check the remaining sleep time at any time
by pressing SLEEP once. Pressing repeatedly will
cycle through the sleep options again.

Dimming the display

You can choose between four brightness levels for the
front panel display. Note that when selecting sources,
the display automatically brightens for a few seconds.
• Press RECEIVER then press DIMMER repeatedly to
change the brightness of the front panel display.

Switching the speaker impedance

We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6 Ω impedance rating. Use
the front panel controls to do this.
• With the receiver in standby, press
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6 Ω.
• SP 8 OHM – Use this setting if your speakers are
rated at 8 Ω or more.
Note
1 You can also switch off the sleep timer simply by switching off the receiver.
50
En
DVR 2
DVD TV DVR1 TV CTRL
XM RADIO
CD CD-R TUNER RECEIVER
SLEEP SB ch ANALOG
ATT
MIDNIGHT/
SR+ DIMMER
LOUDNESS
30 min 60 min
Off 90 min
1
XM RADIO
CD CD-R TUNER RECEIVER
SLEEP SB ch ANALOG
ATT
SR+ DIMMER MIDNIGHT/
LOUDNESS
DIALOG E PHASE S.RETRIEVER
D ACCESS
STANDBY/

Resetting the system

Use this procedure to reset all the receiver's settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the front panel TONE button,
press and hold STANDBY/ON for about three
seconds.
The display shows RESET?.
3 Press the front panel ENTER button.
The display shows RESET OK?.
4 Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.