Table of Contents
Advertisement
Sound Problems
If sound problems are experienced, perform the following actions one at a time to correct the problem.
1.
Reboot the computer.
2.
Navigate to Start
the Device Manager to determine that:
•
•
•
•
3.
Roll back the audio driver to the previous version, if updated recently.
4.
Remove and reinstall the audio driver.
5.
Ensure that all volume controls are set mid range:
a.
b.
6.
Navigate to Start
as the default audio device (green check mark).
NOTE: If Speakers does not show, right-click on the Playback tab and select Show Disabled Devices
(clear by default).
7.
Select Speakers and click Configure to start Speaker Setup. Follow the onscreen prompts to configure
the speakers.
8.
Remove and recently installed hardware or software.
9.
Restore system and file settings from a known good date using System Restore.
If the issue is not fixed, repeat the preceding steps and select an earlier time and date.
10. Reinstall the Operating System.
11. If the Issue is still not resolved, see "Online Support Information" on page 183.
Microphone Problems
If internal or external Microphones do no operate correctly, perform the following actions one at a time to
correct the problem.
1.
Check that the microphone is enabled. Navigate to Start
Sound and select the Recording tab.
2.
Right-click on the Recording tab and select Show Disabled Devices (clear by default).
3.
The microphone appears on the Recording tab.
4.
Right-click on the microphone and select Enable.
5.
Select the microphone then click Properties. Select the Levels tab.
6.
Increase the volume to the maximum setting and click OK.
7.
Test the microphone hardware:
a.
b.
c.
d.
8.
If the Issue is still not resolved, see "Online Support Information" on page 183.
Chapter 4
Downloaded from
www.Manualslib.com
Control Panel
The device is properly installed.
There are no red Xs or yellow exclamation marks.
There are no device conflicts.
No hardware is listed under Other Devices.
Click the volume icon on the taskbar and drag the slider to 50. Ensure that the volume is not muted.
Click Mixer to verify that other audio applications are set to 50 and not muted.
Control Panel
Select the microphone and click Configure.
Select Set up microphone.
Select the microphone type from the list and click Next.
Follow the onscreen prompts to complete the test.
manuals search engine
System and Maintenance
Hardware and Sound
Sound. Ensure that Speakers are selected
Control Panel
System
Device Manager. Check
Hardware and Sound
123
Advertisement
Table of Contents
