Remote Control; Using The Remote Control - Pioneer ELITE SX-A6-J Operating Instructions Manual

03 Controls and displays

Remote control

1
2
TONE/BAL
3
1
4
4
7
DISPLAY
10
BAND
ST
5

1
Switches the receiver between standby and on.
2 Input selector buttons
Press to select an input source.
3 TONE/BAL controls
Use to adjust the tone and balance (page 14).
4 Number buttons
Use the number buttons to directly select a
radio frequency (page 15).
 (TUNE/ST) /ENTER
5
Use the TUNE +/– buttons to find radio
frequencies and use ST +/– to find preset
stations (page 15).
6 DIMMER
Dims or brightens the display (or switches the
backlight off).
7 DIRECT
Press to access Direct listening (page 14).
12
En
DIMMER
6
TAPE PHONO TUNER
AUX1 AUX2 XM
7
DIRECT
L / R /
8
VOL
2 3
9
5 6
MUTE
8 9 0
TUNE
CATEGORY D.ACCESS
MPX
ST
10
ENTER T.EDIT
TUNE RETURN
CLASS
STEREO RECEIVER
8 VOLUME +/–
Use to set the listening volume.
9 MUTE
Mutes/unmutes the sound.
10 Tuner and XM Radio controls
DISPLAY (XM Radio only) – Switches
between named station presets and radio
frequencies (page 15).
BAND (Tuner only) – Switches between the
AM and FM bands (page 15).
CATEGORY (XM Radio only) – Press to
browse digital radio broadcasts (page 17).
MPX (Tuner only) – Switches between
stereo and mono reception of FM
broadcasts (page 15).
D.ACCESS – Press to access a radio
station directly using the number buttons
(page 15).
T.EDIT – Memorizes/names stations for
recall (page 15).
CLASS – Switches between the three
banks of radio station presets (page 15).
RETURN (XM Radio only) – Press to confirm
and exit the current menu.

Using the remote control

Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles
between the remote and the remote sensor
on the unit.
• The remote has a range of about 7 m (23 ft.)
at an angle of about 30º from the remote
sensor.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit's remote sensor.
• Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.