Technics SU-G700 Owner's Manual page 19

Analog audio cable (not supplied)
Using analog audio cable
1 Disconnect the AC power supply cord.
2 Connect this unit and a Blu-ray Disc
player, etc.
3 Connect the AC power supply cord to
this unit. ( 15)
4 Press [AMP ] to turn this unit on.
5 Press [>INPUT<] repeatedly to select
"LINE1" or "LINE2".
• You can also select the input source by
turning the input selector knob on the unit.
• Set to "LINE2" (see below) when "MAIN IN"
is displayed as input source of this unit.
6 Start playback on the connected
device.
When connecting to "LINE2"
Analog audio input terminals (LINE2 IN/MAIN IN)
have both LINE2 IN and MAIN IN functions.
When connecting an analog audio output device,
switch the input setting of this unit to "LINE2".
• The factory default is "LINE2".
1 Press [AMP].
2 Press [>INPUT<] repeatedly to select
"MAIN IN".
3 Press [MENU].
Using analog audio output device (LINE1/LINE2)
You can connect the Blu-ray Disc player, etc. with
analog audio cable (not supplied) to this unit and play
back music.
Blu-ray Disc player, etc.
4 Press [ ], [ ] repeatedly to select
"Input Mode" and then press [OK].
5 Press [ ], [ ] repeatedly to select
"LINE2" and then press [OK].
• The volume level set after switching to
"LINE2" is displayed. Confirm and adjust the
volume before pressing [OK].
6 Press [ ], [ ] to select "Yes" and then
press [OK].
Minimizing sound distortion
If sound distortion occurs when using the analog
audio input terminals, setting the attenuator to
"On" may improve the sound quality.
• The factory default is "Off".
1 Press [AMP].
2 Press [MENU].
3 Press [ ], [ ] repeatedly to select
"Attenuator" and then press [OK].
4 Press [ ], [ ] to select "On" and then
press [OK].
19
Operations
(19)