Description - Siemens RUGGEDCOM RX1510 Installation Manual

Chapter 1
Introduction
Section 1.2

Description

The RUGGEDCOM RX1510 features various ports, controls and indicator LEDs on the front panel for connecting,
configuring and troubleshooting the device.
Figure 1: RUGGEDCOM RX1510
1. Utility USB Port 2. RS232 Serial Console Port (RJ45) 3. Lamp Test/Alarm Cut-Off (LT/ACO) Button 4. Compact Flash Card Port
5. Alarm Indicator LED 6. Port Status LEDs 7. Management Port
Management Port
RS-232 Serial Console Port
Utility USB Port
Lamp Test/Alarm Cut-Off (LT/ACO) Button
Power Status LEDs
Port Status LEDs
Alarm Indicator LED
2
5 6
1
2
3
4
7
This 10/100Base-T Ethernet port is used for system management that is out-of-band from the
switch fabric.
The serial console port is for interfacing directly with the device and accessing initial
management functions. For information about connecting to the device via the serial
console port, refer to
Use the USB port to upgrade the ROX II software or install files, such as configuration files
and feature key files. For more information, refer to the RUGGEDCOM ROX II User Guide for
the RUGGEDCOM RX1510.
This button performs two functions:
• Press and hold this button to test all indicator LEDs
• Press and release this button to acknowledge an active alarm
Indicates the status of the power modules.
• Green = Power is on
• Off = Power is off
Indicates when ports are active.
• Green = OK
• Orange = Warning alert
• Red = Configuration error
Indicates when an alarm condition exists.
• Green = Alarms cleared/acknowledged
Section 2.7, "Connecting to the
RUGGEDCOM RX1510
Installation Guide
Device".
Description