Fastening The Csm And Mounting The Bracket Assembly To A Pole - Motorola PMP 320 Hardware Installation

PMP 320 Hardware Installation
Procedure 5-4
building
1
2
3

Fastening the CSM and mounting the bracket assembly to a pole

If fastening the CSM to a pole, add the pole clamp to the assembly. Perform the following
procedure to fasten the CSM to a pole.
Procedure 5-5
1
2
3
4
PMP320HDW2v1
Attaching the CSM and mounting the bracket assembly outside the
Where possible, install the CSM on the side of the building that has the
greatest exposure to the communications tower of the service provider. The
service provider can provide information about tower locations that can
provide the CSM with the greatest signal exposure.
Drill holes into the exterior wall of the building where the CSM must be hung.
•
Drill the two top holes 2.5 inches apart. Drill the bottom holes 2.5 inches
below the top holes.
•
If possible, drill one upper hole and its corresponding lower hole into a
stud. Do not allow the CSM to be supported by the siding of the building.
•
If installing the CSM on a brick or masonry surface, use appropriate
anchors.
CAUTION
Observe caution when drilling through the wall of the building. Ensure
that there are no power lines, gas lines, water lines, or data lines in
the wall at the desired location where the drilling takes place.
After the holes are drilled into the building, drive the screws through the
holes on the wall bracket and into the building. While attaching the bracket
assembly to the wall, ensure that the bottom of the CSM is pointing towards
the ground. The bottom of the CSM is the side with the five lights and the
grounding lug. The CSM must be installed vertically.
Fastening the CSM and mounting the bracket assembly to a pole
Insert the following through the holes on the clamp:
•
Large hex bolt
•
Large split washer
•
Large washer
Place the clamp around the pole.
Align the screw assembly with the center holes on the wall bracket.
Tighten the clamp so that the bracket assembly and the attached CSM are
tight on the pole.
Preliminary
Fastening the CSM and mounting the bracket assembly to a pole
5-9
JUL 2010