Bank; System; Midi - Boss MD500 Owner's Manual

Parameter List

BANK

You can specify how patches A and B are connected and output when using simul mode.
5 "Using Two Patches Simultaneously (Simul Mode)" (p. 23)

SYSTEM

Parameter
CONTRAST
INSERT LOOP
BANK MODE
BANK EXTENT MIN
BANK EXTENT MAX
KNOB LOCK
KNOB MODE
BYPASS
PEDAL ACT
FSW MODE
USB MODE

MIDI

Parameter
Rx CHANNEL
Tx CHANNEL
PC IN
PC OUT
BANK SEL OUT
CC IN
CC OUT
20
Value
1–16
OFF, ON
Specifies the timing at which the patch is changed when you change banks.
WAIT
IMMEDIATE
01–99
01–99
OFF, ON
IMMEDIATE, HOOK
BUFFERED, TRUE
PUSH, RELEASE
Specifies how the footswitch is used (p. 22).
Specifies the USB operating mode (p. 27).
Value Explanation
Specifies the receive channel.
Ch.1–16, OFF
If this is "OFF, " MIDI messages are not received.
Specifies the transmit channel.
Ch.1–16, Rx, OFF
If this is "OFF, " MIDI messages are not transmitted.
OFF, ON Specifies whether program changes are received.
OFF, ON Specifies whether program changes are transmitted.
Specifies the bank select message that is transmitted simultaneously with the
program change.
MSB, M+L
If you select MSB, only MSB (CC#0) is transmitted. If you select M+L, both MSB
and LSB (CC#32) are transmitted.
OFF, ON Specifies whether control changes are received.
OFF, ON Specifies whether control changes are transmitted.
Explanation
Adjusting the contrast of the display
Specifies whether the insert loop function (p. 24) is used (ON) or not used (OFF).
Switching the bank only changes the indication of the screen, and does not
switch the patch at that point. When you press the [A] or [B] switch, the bank
and number are finalized, and operation switches to the next patch.
Operation immediately switches to the next patch when you switch banks.
Sets the lower limit for the banks.
Sets the upper limit for the banks.
Specifies whether knob operations are disabled (ON) or not disabled (OFF).
When you move a knob, this setting specifies whether control data for that
knob position is always output (IMMEDIATE) or is output only after the knob
position has passed through the current value of the parameter (HOOK).
Specifies how the bypass sound is output (buffered bypass or true bypass).
Specifies whether the operation occurs when you press the [A], [B], or [TAP/CTL]
switch or when you release the switch.