Boss MD500 Owner's Manual page 19

Parameter Value
ACT LOW 0–126
ACT HIGH 0–127
0–100, –
WAVE RATE (*1)
* If, due to the tempo, the time is longer than the range of allowable settings, it is then synchronized to a
WAVE FORM (*1) SAW, TRI, SIN
Specifies how the motion of the internal pedal will be triggered.
PAT CNG
(PATCH CHANGE)
EXP LOW
TRIGGER
EXP MID
(INT PEDAL TRIGGER)
(*2)
EXP HIGH
CTL1, 2 PDL
CC#1–#31
CC#64–#95
TIME
(INT PEDAL TIME) 0–100
(*2)
CURVE LINEAR,
(INT PEDAL CURVE)
SLOW (SLOW RISE),
(*2) FAST (FAST RISE)
*1: SRC=WAVE PDL only
*2: SRC=INT PDL only
Explanation
Within the operating range of the source, this specifies the range that will
control the target parameter.
The target parameter will be controlled within the range specified. Normally, you
should leave ACT LOW at "0" and ACT HIGH at "127. "
Specifies the time for one cycle of the wave pedal.
period either 1/2 or 1/4 of that time.
Select one of the following to specify the change produced by the wave pedal.
SAW
This is activated when a patch is selected.
This is activated when an external expression pedal connected to the CTL 1,2/
EXP jack is set to the minimum position.
This is activated when the external expression pedal connected to the CTL 1,2/
EXP jack is moved through the middle position.
This is activated when the external expression pedal connected to the CTL 1,2/
EXP jack is set to the maximum position.
This is activated when an external footswitch connected to the CTL 1,2/EXP jack
is operated.
This is activated when a control change is received.
This specifies the time over which the internal pedal will move from the toe-
raised position to the toe-down position.
Select one of the following curves to specify the change produced by the
internal pedal.
LINEAR
TRI SIN
SLOW FAST
Parameter List
19