Boss MD500 Owner's Manual page 11

Parameter Value
CE-1 CHORUS, CE-1 VIBRATO
RATE 0.01–20.00 Hz
BPM 6.0–600.0
` – Œ
NOTE
DEPTH 0–100
LOW LEVEL -50–+50
LOW FREQ 20.0–800 Hz
HIGH LEVEL
-50–+50
HIGH FREQ 630–16.0 kHz
PREAMP SW OFF, ON
PREAMP GAIN 1–100
PREAMP LEVEL
0–100
Specifies the output of the chorus.
MONO
OUTPUT MODE
STEREO
TRI-CHO
RATE (*1) 0.01–20.00 Hz
BPM (*1) 6.0–600.0
` – Œ
NOTE (*1)
Selects the LFO mode.
PRESET
LFO MODE
MANUAL
P+M
INTENSITY1 (*2) 0–100
INTENSITY2 (*2) 0–100
INTENSITY3 (*2) 0–100
BRIGHT OFF, ON
LOW LEVEL -50–+50
LOW FREQ 20.0–800 Hz
HIGH LEVEL -50–+50
HIGH FREQ 630–16.0 kHz
OUTPUT MODE MONO, STEREO
*1: Unavailable if LFO MODE is "PRESET"
*2: Shown if LFO MODE is "MANUAL" or "P+M"
Explanation
Adjusts the rate of the chorus.
Specifies the tempo.
The range of this setting depends on the RATE or NOTE value.
Adjusts the rate of the chorus, specified as a note value relative to BPM.
Adjusts the depth of the chorus.
Adjusts the low frequency range tone.
Specifies the frequency adjusted by the LOW LEVEL setting.
Adjusts the high frequency range tone.
Specifies the frequency adjusted by the HIGH LEVEL setting.
Specifies whether the CE-1's preamp is simulated (ON) or not simulated (OFF).
Adjusts the gain of the preamp. Higher settings will produce distortion.
Adjusts the volume of the preamp.
Mono output.
Direct sound is output from the OUTPUT A/MONO jack, and effect sound is
output from the B jack.
Adjusts the rate of the chorus.
Specifies the tempo.
The range of this setting depends on the RATE or NOTE value.
Adjusts the rate of the chorus, specified as a note value relative to BPM.
The RATE is fixed (4.98 Hz).
RATE adjusts the rate of the chorus.
The PRESET and MANUAL LFOs are summed.
Adjust the depth of the three-phase chorus.
Specifies whether the high-frequency region of the effect sound is boosted (ON)
or not boosted (OFF).
Adjusts the low frequency range tone.
Specifies the frequency adjusted by the LOW LEVEL setting.
Adjusts the high frequency range tone.
Specifies the frequency adjusted by the HIGH LEVEL setting.
Specifies whether the output is mono (MONO) or stereo (STEREO).
Parameter List
11