Boss MD500 Owner's Manual page 13

Parameter Value
OFF, ª – `
STEP RATE
Bi-PHASE
OFF, ON
OUTPUT MODE
MONO, STEREO
SCRIPT
RATE 0.01–20.00 Hz
BPM
6.0–600.0
` – Œ
NOTE
DEPTH 0–100
CLASSIC-VIBE
Parameter Value
Selects the type of output.
TYPE CHORUS
VIBRATO
RATE
0.01–20.00 Hz
BPM 6.0–600.0
` – Œ
NOTE
DEPTH 0–100
VIBRATO
Parameter Value
Selects the type of vibrato.
TYPE PRIME
SCANNER
PRIME
RATE
0.01–20.00 Hz
BPM 6.0–600.0
` – Œ
NOTE
DEPTH 0–100
COLOR 0–100
TRIGGER
OFF, ON
RISE TIME
0–100
ENVELOPE SENS
0–100
WAVEFORM
1–10
INPUT SENS
0–100
SCANNER
SCAN SPEED
0.01–20.00 Hz
BPM 6.0–600.0
` – Œ
NOTE
Selects the SCANNER mode.
V1–V3
MODE
C1–C3
Explanation
Adjusts the rate of the step function which varies the rotation in a step-wise
manner. Higher settings make the change occur in smaller steps. Turn this "OFF"
if you don't want to use the step function.
Specifies whether the two phase shift circuits are connected in series (ON) or
not (OFF).
Specifies whether the output is mono (MONO) or stereo (STEREO).
Adjusts the speed of rotation.
Specifies the tempo.
The range of this setting depends on the RATE or NOTE value.
Adjusts the speed of rotation, specified as a note value relative to BPM.
Adjusts the depth of the rotation effect.
Explanation
Direct sound and effect sound are mixed and output.
Only effect sound is output.
Adjusts the rate at which the effect is applied.
Specifies the tempo.
The range of this setting depends on the RATE or NOTE value.
Adjusts the rate at which the effect is applied, specified as a note value relative
to BPM.
Adjusts the depth at which the effect is applied.
Explanation
A vibrato unique to the MD-500. A wide range of settings are possible.
Simulates the scanner vibrato of a tonewheel organ.
Adjusts the rate of vibrato.
Specifies the tempo.
The range of this setting depends on the RATE or NOTE value.
Adjusts the rate of vibrato, specified as a note value relative to BPM.
Adjusts the depth at which vibrato is applied.
Higher settings produce a more complex modulation.
Turns the vibrato on/off.
Specifies the time from when trigger turns on until the specified vibrato effect
is obtained.
Adjusts the time over which the vibrato depth reaches the maximum according
to the input.
Selects the type of wave.
The vibrato depth changes according to the input. If this is set to "0, " vibrato is
applied at a fixed depth regardless of the input. With higher values, less vibrato is
applied for louder input.
Adjusts the speed of vibrato.
Specifies the tempo.
The range of this setting depends on the SCAN SPEED or NOTE value.
Adjusts the speed of vibrato, specified as a note value relative to BPM.
Applies vibrato. Higher values produce a deeper effect.
Applies chorus. Higher values produce a deeper effect.
Mixes effect sound with direct sound, adding depth to the sound.
Parameter List
13