Event Settings - LG LDV-S504 Owner's Manual

Event Settings

Event Settings
Sensor
In : Displays the number of SENSOR-IN terminal.
Sensor Type : The alarm state can be set to either
N/O (Normally Open) or N/C (Normally Closed).
Camera : Select the connected camera channel
with the SENSOR-IN terminal.
Output : Select the alarm output number of
ALARM-OUT terminal for output alarm signal.
Motion
Channel : Select the channel to set the motion
detection.
Sensitivity : Set the sensitivity for the created
motion detection area. Sensitivity can be set 0 to
10 level.
Alarm Out : Select the number of ALARM-OUT ter-
minal for output alarm signal when the motion
detected.
Area : Select the desired motion detection area on
the preview window screen.
- b / B / v / V : Moves the yellow cell box to
other cell zone.
- ENTER : Selecting or cancelling the motion
detection area at the current cell position.
- Press ESC to exit the settings.
Note :
You can select the motion detection area by using the
mouse.
- To select area : Drag&Drop a cell to the right
direction to select the motion detection area.
- To cancel area : Drag&Drop a cell point of select-
ed cell area to the left direction to cancel the
motion detection area.
Etc
Alarm Off
- MANUAL : Use the ALM.OFF to stop alarm.
- POST-ALARM TIME : Select the post alarm time.
31