Connecting Using The Component Video; Output; About Progressive Scan Video - Pioneer S-DV131 Operating Instructions Manual

Other connections
Connecting using the
component video output
If your TV has component video inputs, you can
use these instead of the standard video output
to connect this system to your TV.
give you the best quality picture from the three
types of video output available.
• Use a component video cable to connect
the COMPONENT VIDEO OUT to a set of
component inputs on your TV.
TV
COMPONENT
C /
B
VIDEO OUT
P
B
VIDEO C /
R
OUT P
R
S-VIDEO
Y
OUT
VIDEO
XV-DV131/232T

About progressive scan video

Compared to interlace video, progressive scan
video effectively doubles the scanning rate of
the picture, resulting in a very stable, flicker-
free image. Progressive scan video is available
only from the component video output.
Note
1 The component video output is switchable between interlaced and progressive formats. See Video Output settings on page 20.
2 Consumers should note that not all high-definition television sets are fully compatible with this product and may cause
artifacts to be displayed in the picture. In case of 525 progressive scan picture problems, it is recommended that the user switch
the connection to the 'standard definition' output (Interlace). If there are questions regarding our TV set compatibility with this
model, please contact our customer service center.
• If you connect a TV that is not compatible
1
This should
Compatibility of this player with
progressive-scan and high-definition TVs.
This player is compatible with progressive
video Macro Vision System Copy Guard.
COMPONENT
This system is compatible with the following
INPUT
Pioneer displays and monitors:
Plasma display (Taiwanese model )
PDP-502MX, PDP-503HDG, PDP-433HDG,
PDP-5040HD, PDP-4340HD, PDP-505HDG,
PDP-435HDG
LINE
IN OUT
Projection monitor receiver (Taiwanese model)
L
SD-532HD5, SD-533HD5
R
Plasma display (All other models)
AUDIO
PDP-503HDG, PDP-433HDG, PDP-504HDG,
PDP-434HDG, PDP-505HDG, PDP-435HDG
Important
with a progressive scan signal and switch
the system to progressive, you will not be
able to see any picture at all. In this case,
STANDBY/ON to put the system
press
in standby, then press SHIFT+SYSTEM
SETUP , use the
button to select INTER L . Press ENTER to
set to interlace and switch the system back
on.
06
(cursor left/right)
2
27
En