Scheduler Association; Bandwidth Utilization - Cisco WAP 121 Administration Manual

Scheduler Association

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
REVIEW DRAFT Version 2—CISCO CONFIDENTIAL
The Scheduler profiles need to be associated with the WLAN interface or a VAP
interface to be effective. By default, there are no Scheduler profiles created, hence
no profile is associated to any radio or VAP.
Only one Scheduler profile can be associated with the WLAN interface or each
VAP. A single profile can be associated to multiple VAPs. If the Scheduler profile
associated with a VAP or the WLAN interface is deleted, then the association is
removed.
To associate a Scheduler profile with the WLAN interface or a VAP:
Click >
For the WLAN interface or a VAP, select the profile from the
list.
Click . The changes are saved to the Running Configuration and to the Startup
Configuration.
Use the Bandwidth Utilization page to configure how much of the radio bandwidth
can be utilized before the AP stops allowing new client associations. This feature
is disabled by default.
To enable bandwidth utilization:
Click >
Click for the
In the
bandwidth utilization allowed on the radio before the AP stops accepting new
client associations.
The default is 0, which means that all new associations will be allowed regardless
of the utilization rate.
Click . The changes are saved to the Running Configuration and to the Startup
Configuration.
in the navigation window.
in the navigation window.
setting.
box, enter the percentage of network
58