Pioneer PDP-LX508G Operating Instructions Manual page 18

05 Preparation
Attaching and removing speed clamps
Insert [1] into an appropriate hole on the rear of the plasma
television and snap [2] into the back of [1] to lock the clamp.
1
• Speed clamps are designed to be difficult to undo once in
place. Please attach them carefully.
• Use pliers to twist the clamp 90º, pulling outward. The clamp
may deteriorate over time and become damaged if removed.
• Be careful not to subject any connecting cables to strain.
Note
• Use the speed clamps as necessary.
Tidying the speaker cables
Use the supplied bead bands as necessary to tidy the speaker cables.
Rear view
18
En
2
Speaker cable
MONITOR SUB
OUT WOOFER
Bead band
Attaching the ferrite core
(when a ferrite core is not attached)
To help prevent noise, attach the supplied ferrite core to the
connector end of the power cord as shown. Use the supplied cable
tie to prevent the ferrite core from slipping on the cable.
1
2
To power outlet
AC power cord
Connecting the power cord
Rear view
MONITOR SUB
OUT WOOFER
Power cord
Note
• Disconnect the power cord from the power outlet when the
plasma television is not going to be used for a long period of time.
• After all other components are connected, connect the power
plug to the AC outlet.
4
3
Ferrite core
Cable tie
As close as possible
Ferrite core
Partially eliminates noise
caused by the power source.
To power outlet