Preparing The Remote Control Unit; Inserting Batteries; Cautions Regarding Batteries; Allowed Operation Range Of The Remote Control Unit - Pioneer PDP-4214HD Operating Instructions Manual

Preparation

Preparing the remote control unit

Inserting batteries

1
Open the battery cover.
2
Insert the supplied two AAA (1.5 V) size batteries.
• The battery polarities must correspond with the (+) and
(–) indicators in the battery compartment.
3
Close the battery cover.

Cautions regarding batteries

• The remote control unit cannot operate the system if the
batteries in the unit are empty. When this happens, replace
the batteries with new ones.
• Do not use manganese batteries. When you replace the
batteries, use alkaline ones.
• Do not mix batteries of different types. Different types of
batteries have different characteristics.
• Do not mix old and new batteries. Mixing old and new
batteries can shorten the life of new batteries or cause
chemical leakage in old batteries.
• Do not leave dead batteries in the remote control unit;
chemical leakage will occur. If you find any chemical leakage,
wipe thoroughly with a cloth.
• The batteries supplied with this product may have a shorter
life expectancy due to storage conditions.
• If you will not use the remote control unit for an extended
period of time, remove the batteries from it.
• WHEN DISPOSING OF USED BATTERIES, BE SURE
TO COMPLY WITH GOVERNMENT REGULATIONS
AND ENVIRONMENTAL PROTECTION GUIDELINES
THAT APPLY IN YOUR COUNTRY OR AREA.
Allowed operation range of the remote control
unit
Operate the remote control unit while pointing it toward the
remote control sensor located at the bottom center of the front
panel of the Plasma Display. The distance from the remote
control sensor must be within 7 m (23 feet) and the angle
relative to the sensor must be within 30 degrees in the right or
left direction.
POW ER
30°
30°
STAN DBY
DTV
TV
VCR
DVD
HDM I
Remote control
sensor
05
15
En