Troubleshooting; General - Pioneer XW-DV1WS Operating Instructions Manual

13 Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.
• If the system does not operate normally due to external effects such as static electricity
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
• If you are experiencing problems with the wireless speaker system, make sure to bring both
the transmitter and wireless speaker in for repair so that they can be tested properly.

General

Problem
The power does not
turn on.
No sound is output
when a function is
selected.
No image is output
when playing discs.
No sound from
surround or center
speakers.
Can't operate the
remote control.
72
En
Remedy
• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear
panel. This could cause the system to shut off automatically.
• If you're using the line input, make sure the component is connected
correctly (see Connecting auxiliary components on page 59).
MUTE
• Press on the remote control to turn muting off.
VOLUME
• Adjust the
• If you're using the TV input, make sure you've selected the RCA audio input
(see Switching the TV audio input from SCART to RCA on page 63).
• Make sure the TV is connected correctly (refer to the Setup Guide).
• Not applicable to the European model – Reset the video output to interlace
(see Video Output settings on page 55).
• Refer to Setting the channel levels on page 52 to check the speaker levels.
• Check that you haven't selected the STEREO sound mode (see Listening in
surround sound on page 30).
• Connect the speakers properly (refer to the Setup Guide).
• Replace the batteries (refer to the Setup Guide).
• Operate within 7 m, 30° of the remote sensor on the front panel (refer to the
Setup Guide).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• You won't be able to use the remote sensor of this unit with the CONTROL
IN jack of this unit connected to the CONTROL OUT jack of your plasma
display. You can use the remote sensor of the plasma display (even in
standby) as long as the power isn't switched off.
.