Operating Environment - Pioneer XW-DV1WS Operating Instructions Manual

[Excluding XW-DV525/XW-DV1WS]
CAUTION
This product contains a laser diode of higher class
than 1. To ensure continued safety, do not remove any
covers or attempt to gain access to the inside of the
product.
Refer all servicing to qualified personnel.
The following caution label appears on your unit.
CAUTION : USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
CAUTION : THE USE OF OPTICAL INSTRUMENTS WITH THIS PRODUCT WILL INCREASE EYE HAZARD.
The channel, fr equency, output power , and other featur es and functions of the equipment shall not be
changed after appr oval.
The equipment shall safely use only a channel fr equency that is legally appr oved and shall not cause
inter ference on other channels. If the equipment fails to meet these r
equipment will be pr ohibited until compliance can be attained.
[Excluding XW-DV525/XW-DV1WS]
This product complies with the Low Voltage Directive
(73/23/EEC, amended by 93/68/EEC), EMC Directives
(89/336/EEC, amended by 92/31/EEC and
93/68/EEC).

Operating Environment

Operating environment temperature and humidity:
+5 ºC – +35 ºC (+41 ºF – +95 ºF); less than 85 %RH
(cooling vents not blocked)
Do not install in the following locations
• Location exposed to direct sunlight or strong artificial
light
• Location exposed to high humidity, or poorly
ventilated location
[XV-DV525 only]
The STANDBY/ON switch is secondary connected
and therefore, does not separate the unit from mains
power in STANDBY position. Therefore install the
unit suitable places easy to disconnect the MAINS
plug in case of the accident. The MAINS plug of unit
should be unplugged from the wall socket when left
unused for a long period of time.
[XW-DV525/XW-DV1WS only]
CAUTION
The POWER switch does not completely separates
the unit from the MAINS in off position. Therefore
install the unit suitable places easy to disconnect
D3-4-2-1-9a_En
the MAINS plug in case of the accident. The MAINS
plug of unit should be unplugged from the wall
socket when left unused for a long period of time.
Energy-saving design
This system is designed to use 0.5W of
electricity when power is switched to
standby.
D3-4-2-1-7c_En
D3-4-2-2-2a_En
CLASS 1
LASER PRODUCT
equirements, use of the
[For XV-DV525 only]
For U.S. and Australia Model
C67-7-3_En
D3-4-2-1-8_En
D6-8-2-1_En
D3-4-2-2-2b_En