Pioneer RCS-404H Operating Instructions Manual page 88

Playback
07
Playing CDs and WMA/MP3 discs
The table below shows the basic playback controls for
1
audio CDs , and WMA/MP3 files.
Press to start playback.
PLAY
Press to stop playback.
STOP
Pauses playback, or restarts playback when
PAUSE
paused.
Except WMA: Press to start scanning. Press
again to increase the scanning speed. (There
are two scan speeds; the current scan speed
is shown on-screen.)
Press to skip to previous/next track (or folder
PREV NEXT
for WMA/MP3 disc). (During playback you
can also use the front panel CH +/– buttons.)
During playback, enter a track number then
SET UP /TUNE+ SR+
1 2 3
press ENTER to skip directly to that track.
/ST– ENTER /ST+
Press CLEAR to clear a number entry and
4 5 6
MCACC /TUNE– TEST TONE
start again.
7 8 9
ADVANCED SOUND
0
CLEAR
ENTER
Note
1 If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with a digital connection. Noise
will be output through the analog outputs. Also make sure that Stereo is selected using the AUDIO button (see Switching audio channels on
page 94).
2 When playing in PBC mode, some playback features, such as search, repeat and program play are not available. You can play a PBC Video
CD/Super VCD in non-PBC mode by pressing
88
En
Playing Video CD/Super VCDs
The table below shows the basic playback controls for
Video CD/Super VCDs.
Some discs feature Playback Control (PBC for short)
menus. These discs show PBC in the display when you
load them and display a menu on-screen from where you
can select what to watch.
PLAY
STOP
PAUSE
PREV NEXT
SET UP /TUNE+ SR+
1 2
/ST– ENTER
4 5
MCACC /TUNE– TEST TONE
7 8
ADVANCED SOUND
0
CLEAR
ENTER
CM
BACK
ENTER
RETURN
to start playback instead of PLAY.
2
Press to start playback.
Video CD only: If RESUME is displayed on-
screen, playback starts from the place last
stopped.
Press to stop playback.
Video CD only: You can resume playback
from the same point by pressing
(Press STOP again to cancel the resume
function.)
Pauses playback, or restarts playback
when paused.
Press to start scanning. Press repeatedly to
increase the scanning speed.
Press to skip to previous/next track.
When a PBC menu is displayed, press to
display the previous/next page. (During
playback you can also use the front panel
CH +/– buttons.)
During playback, enter a track number
3
then press ENTER to skip directly to that
/ST+
6 track.
Press CLEAR to clear a number entry and
9
start again.
While a PBC menu screen is displayed, use
to select numbered menu items.
Video CD only: Each press skips backward/
forward progressively up to a maximum of
CM
SKIP
ten minutes forward or three minutes back.
Note that this function doesn't work when
playing in PBC mode.
While paused, press and hold to start slow-
motion playback. Press repeatedly to
change the playback speed (forward only).
While paused, press to advance a single
frame (forward only).
Press to display the disc menu of a Video
CD/Super VCD playing in PBC mode.
PLAY.