Pioneer RCS-404H Operating Instructions Manual page 144

Additional information
16
Message
• Please perform HDD optimization. This
can be done using Disc Setup.
• The HDD has not been sufficiently opti-
mized. Please optimize again.
• This channel's TV system is different
from the recorder's setting.
• Recording failed due to a TV system
mismatch. Press DISPLAY to clear
message.
• Playback has stopped because the TV
system is different than the recording.
No DV camcorder connected.
You cannot connect more than one DV
camcorder at a time.
Cannot operate the DV camcorder.
Could not operate the DV camcorder.
The DV camcorder is not set for playback.
Please select playback mode on the DV
camcorder.
Searching for printer. Please wait a
moment.
The printer is not ready or there is no
printer connected. Please check the
printer status.
Printing has stopped because ...
The print job has been canceled because
...
144
En
Explanation/Action
The HDD is in more urgent need of optimization in order to maintain
performance.
If this message appears repeatedly after optimizing the HDD it is likely
that there is not enough free space on the HDD for optimization to
complete properly. Please erase some titles from the HDD and optimize
again.
The TV system (PAL, NTSC, etc.) of the current channel is different from
the TV system settings of this recorder.
The timer recording failed because the TV system of the channel set for
recording was different from the setting of the recorder.
During recording or timer recording standby, the TV System (PAL, NTSC,
etc.) of the playback video changed, causing playback to stop
automatically.
The camcorder is not connected properly, or the camcorder is switched
off.
This recorder's DV jack supports connection to just one camcorder.
This recorder cannot operate the DV camcorder. Try switching off the
camcorder then turn it back on again.
This recorder was not able to operate the DV camcorder.
The camcorder is in camera mode. Switch it to playback mode.
This message is displayed when the recorder is scanning for a
connected printer, or when the printer is not yet ready for printing. If
there is no printer connected, please connect one.
This message is displayed when communication could not be
established with the printer. See the Troubleshooting section if you do not
know the cause.
This message is displayed when there is a printer error during printing.
After checking the printer for the cause of the error, select "Yes" to
resume printing. Select "No" to cancel the print job. See also the
operating instructions that came with your printer for possible causes of
print errors.
This message is displayed when there is a printer error during printing.
After checking the printer for the cause of the error, reconnect the printer
and start the printing job again. See also the operating instructions that
came with your printer for possible causes of print errors.