Setup - Amprobe WT-50 User Manual

Setup

The advanced setup mode lets you customize your meter.
9 parameters are available in this model.
P1.0: Clear memory
P2.0: Select Units
P3.0: Coefficient settings
P4.0: Ready indication
P5.0: Auto power off time
P6.0: Real time clock
P7.0: Beta (membrane temperature coefficient)
P8.0: View Calibration data
P9.0: Reset
To enter SETUP mode, hold down "POWER/SET" for some seconds to turn
on the meter. Press "MODE" or "MEM" to select parameters and press
"MNX/AV/ENTER" (indicates "ENTER" in the following instructions) for
parameter settings. To exit any setting, press CAL/Esc.
Note: P0.0 Print function is not available in this model.
P1.0: Clear memory
In P1.0, press "ENTER" go into P1.1. Select "n"-NO or "y"-YES with
"MODE" or "MEM" (Fig. 3), then press "ENTER" to confirm to clear all
memories or not.
P2.0: Select Units
In P2.0, press "ENTER" to go into P2.1. Select temperature unit °F or °C with
"MODE" or "MEM" and then press "ENTER" to P2.2 for selecting DO
unit in mg/l or ppm. Press "ENTER" again to confirm the unit selection and
return to P2.0.
Fig. 3
5