Generator - Stihl MS 440 Service Manual

1
– Remove the front handle –
b 12.8
: Pull the connecting lead out of
the opening.
Reassemble in the reverse
sequence.
: Lay the connecting leads in the
recess (1) when fitting the front
handle.
88
14.5

Generator

– Remove the ignition module –
b 7.1.2
– Remove the flywheel – b 7.3
: Break the connection (1).
: Take out the screws (arrows).
– Remove the generator.
: There must not be any cracks or
other signs of damage on the
generator and poles, otherwise
they must be replaced.
1
: There must not be any cracks or
other signs of damage on the
magnet ring (arrow) in the flywheel,
otherwise it must be replaced.
Reassemble in the reverse
sequence.
: Position the generator with the
connecting lead (1) facing the
housing.
: The connecting lead must be
located beside the recess (2) in
the housing.
– Secure the screws with
Loctite 242 – b 16.
– Tighten down the screws – b 3.5
Reassemble the remaining parts in
reverse order.
MS 440, MS 440 C
2
1