JVC NX-F3B Service Manual page 15

3.1.9 Removing the Rear panel (See Fig.20)
(1) Remove the two screws S attaching the Rear panel.
3.1.10 Removing the Power board (See Fig.21)
(1) Disconnect the power cord connected to connector
the Power board.
(2) Remove the five screws T attaching the Power board.
3.1.11 Removing the Amp board (See Fig.22)
(1) Remove the two screws U attaching the Barrier.
(2) Remove the three screws V attaching the Heat sink.
(3) Remove the two screws W attaching the Amp board.
3.1.12 Removing the Front board (See Fig.23)
(1) Remove the eight screws X attaching the Front board.
CN1 of
T
CN1
T
U
S
Fig.20
T
Fig.21
Fig.22
X
X
Fig.23
(No.MB662<Rev.003>)1-15
V
W