JVC NX-F3B Service Manual page 12

3.1.4 Removing the Top chassis (See Fig.10 to 13)
(1) Remove the six screws G attaching the Rear panel. (See
Fig.10)
(2) Remove the two screws H attaching the right side of Top
chassis. (See Fig.11)
(3) Remove the one screw J and one screw K attaching the left
side of Top chassis. (See Fig.12)
CAUTION:When remove the screw K, use screw driver is next.
TORX Driver: size T10
Parts number: DR-L70
(4) Slide to frontward, and then turnover the Top chassis.
(5) Disconnect the card wires from Micon board connected to
connectors CN101 and
Fig.13)
(6) Disconnect the connector wire from Power board connect-
ed to connector CN103
1-12 (No.MB662<Rev.003>)
CN102 of the Amp board. (See
of the Amp board. (See Fig.13)
G
Fig.10
H
Fig.11
J
Fig.12
CN101 CN102
Fig.13
K
CN103