Starting The Spt 1700 - Symbol SPT 1700 Series Quick Reference

S P T

Starting the SPT 1700

After charging and installing the battery, start the terminal by
pressing the red power button. If the terminal does not power on,
perform a hard reset by following the instructions on page 14.
Calibrating the Screen
The first time you start your SPT 1700, the calibration screen
appears. Follow the steps in this section to align the internal
circuitry of your SPT 1700 with its touch-sensitive screen.
Note: If your SPT 1700 unit came pre-loaded with a custom
software application, you may not need to calibrate
your screen, in which case you will not see the calibra-
tion screen.
To calibrate your SPT 1700:
1. Press the power button on the front panel of your SPT 1700
to display the calibration screen. (This screen also displays fol-
lowing a hard reset).
Power
Button
Note: If necessary, adjust the contrast control on the SPT 1700
so the screen is clear and readable. See Using the Con-
trast Control on page 10 for instructions.
2. Remove the stylus from its storage silo on the back of the SPT
1700.
1 7 0 0
8
S e r i e s