Mounting Method - Mitsubishi Electric MR-J2M-P8B Instruction Manual

2. INSTALLATION AND START UP

2.5 Mounting method

(1) Base unit
As shown below, mount the base unit on the wall of a control box or like with M5 screws.
(2) Interface unit/drive unit (MR-J2M-40DU or less)
The following example gives installation of the drive unit to the base unit. The same also applies to the
interface unit.
1) Hook the catch of the drive unit in the positioning hole of the base unit.
2) Using the catch hooked in the positioning hole as a support, push the drive unit in.
2 - 4
www.dadehpardazan.ir 88594014-15
Wall
Sectional view
Drive unit
Catch
Sectional view
2)
Drive unit
Base unit
Wall
1)
Positioning hole
Base unit
Wall