Dv-667A Taiwanese Model Only: Connecting Using The D1/D2 Video Output - Pioneer DV-563A Operating Instructions Manual

02 Connecting up
Connecting using the
component video output
You can use the component video output
instead of the standard video out jack to
connect this player to your TV (or other equip-
ment). This should give you the best quality
picture from the three types of video output
available.
• Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.
TV
DIGITAL COAXIAL
AUDIO OUT
S
OPTICAL
• To set up the player for use with a progres-
sive scan TV, see Component Out on
page 56.
• Only NTSC video is output when set to
progressive scan.
16
En
COMPONENT
VIDEO IN
AUDIO OUT(2CH)
Y
P
B L
L
CENTER
AUDIO OUT
(5.1CH)
R SUB
P R
FRONT SURROND WOOFER
R
VIDEO OUT
COMPONENT VIDEO OUT
DV-667A Taiwanese model
only: Connecting using the
D1/D2 video output
If your TV is equipped with a D type video
input, you can use a D video cord to connect
this player to your TV.
TV
CONTROL
IN OUT
DV-667A Taiwanese model
• Only NTSC video is output when set to
progressive scan.
• This player is compatible with D1, D2, D3
and D4 input jacks, however, when
connected to a D1 jack, only interlace
video is output.
• If you connect the S-video jack and the D
video connector, and one of the
connected components is not S1/S2
compatible, the automatic aspect ratio
switching will not work with any of the
connected components.
D1/D2
VIDEO INPUT
DIGITAL
D1/D2 COAXIAL
AUDIO OUT
VIDEO OUT
S
OPTICAL