Installing The Batteries - Vivitar ViviCam S1527 User Manual

INSTALLING THE BATTERIES

1) Use only the specified batteries for the camera.
Use 4 x AA (1.5V) batteries. Alkaline batteries are recommended. Batteries not included.
Note: When replacing batteries, always power off the camera before removing the batteries.
2) Push the clip in the direction of the arrow and then slide the battery cover to the right to
release and open it.
3) Make sure the batteries have been inserted properly into your digital camera, according to
the polarity shown inside the battery compartment.
4) Close the battery compartment cover and then slide the clip to the left to securely lock the
cover in place.
Note:

Remove the batteries from the camera when not in use for an extended period.

Do not mix alkaline and non-alkaline batteries.

Rechargeable batteries not recommended.

Some features, such as Flash, will not work if the battery power level is low.

When the battery power is low the battery icon turns red and the camera will
automatically turn off a few seconds later.

Battery Status:
Icon Description
Battery power is full.
Battery power remains adequate.
Battery power is low.
Battery power is very low. You should replace the batteries ASAP.
6