JVC UX-S77 Service Manual page 8

3.1.2 Removing the top cover (See Figs.5 to 7)
• Prior to performing the following procedure, remove the side
panels L/R.
(1) From the back side of the main body, remove the screw E
attaching the top cover to the rear cover. (See Fig.5)
(2) From the right side of the main body, disconnect the card
wires from the connectors
board. (See Fig.6)
(3) From the both sides of the main body, remove the two
screws F attaching the top cover to the front panel assem-
bly. (See Fig.7)
(4) Release the claws b and remove the top cover from the
main body in the direction of the arrow. (See Fig.7)
1-8 (No.MB230)
CN790 and CN791 on the main
E
Rear cover
Fig.5
Top Cover
CN791
Fig.6
Front panel assembly
Top cover
F
Claw b
Claw c
G
Bottom chassis
Fig.7
Top cover
Main board
CN790
Top cover
F
Claw b
Claw c