JVC UX-S77 Service Manual page 25

3.2.11 Removing the side (L) assembly and tray switch board
(See Figs.19 to 21)
• Prior to performing the following procedures, remove the tray
assemblies.
(1) From the topside of the DVD changer mechanism assem-
bly, remove the two screws T attaching the side (L). (See
Fig.19.)
(2) From the left side of the DVD changer mechanism assem-
bly, remove the spacer fixing the tray switch board and mo-
tor board. (See Fig.20.)
(3) Disconnect the connector
from the motor board and detach the side (L) in an upward
direction. (See Fig.20.)
(4) Remove the screw U attaching the tray switch board to the
side (L). (See Fig.21.)
(5) Release the joint tab s of the side (L) in the direction of the
arrow 1 and release the joint tab t while removing the tray
switch board in the direction of the arrow 2. (See Fig.21.)
CN3 on the tray switch board
SIde(L)
Fig.19
T
T
Motor board
Side(L)
Fig.20
Side(L)
Tray switch board
Fig.21
T
T
CN3
Tray switch board
s
1
2
t
U
(No.MB230)1-25