JRC JMR-7230-S3 Instruction Manual page 35

Setting Item
Gyro 1. Select the check box and enable the serial port for the
Gyro.
2. Select a sensor to be connected to the serial port for
Gyro from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
LOG 1. Select the check box and enable the serial port for the
LOG.
2. Select a sensor to be connected to the serial port for
LOG from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
GPS 1. Select the check box and enable the serial port for the
GPS.
2. Select a sensor to be connected to the serial port for
the GPS from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
AIS 1. Select the check box and enable the serial port for the
AIS.
2. Select a sensor to be connected to the serial port for
the AIS from the [Sensor] combo box. When not
selecting a sensor, set [ - ].
Table A: Sensors that can be selected by serial ports on CCU
Serial port
Gyro Heading Sensor (NMEA) , Heading Sensor1 (NMEA)
Heading Sensor (Gyro I/F) , Heading Sensor1 (Gyro I/F)
I/F)
LOG Log (NMEA) , Log1 (NMEA)
Log (Gyro I/F)
Selector
GPS GPS 1
GPS 2
GPS 3
GPS 4
Selector
AIS AIS
* 1 : Only when two heading sensors are available
Only when two logs are available
*2
*3 Only when Heading Sensor (Gyro I/F) is selected for Gyro of CCU
May not be displayed depending on the number of GPS units
*4
Description of Setting
*1
*2 , Log2 (NMEA)
*3
*4
*4
*4
19-23
To enable: Select.
To disable: Clear.
To enable: Select.
To disable: Clear.
To enable: Select.
To disable: Clear.
To enable: Select.
To disable: Clear.
Sensor name
, Heading Sensor2 (NMEA)
*1
*1 , Heading Sensor2 (Gyro
*2
Section 19 Adjusting and Setting up Equipment (for Services)
Setting Value
*1
１
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
APP A
APP B