Figure - Craftsman 247.88976 series Operator's Manual

Chute Clean-Out Tool
A chute clean-out tool is fastened to the top of the auger housing with a mounting
clip. See Figure 42. The tool is designed to clear a chute assembly of ice and
snow. This item is fastened with a cable tie at the factory. Cut the cable tie before
operating the snow thrower.
Never use your hands to clear a clogged chute assembly. Shut OFF engine
and remain behind handles until all moving parts have stopped before
using the clean-out tool to clear the chute assembly.
Drift Cutters (if equipped)
1. Remove the two screws and wing knobs that secure each drift cutter, and
remove them from the sides of the auger housing.
2. Turn the drift cutters around and position them as shown in Figure 43 to the
outside of the auger housing.
WARNING
Chute Clean-Out Tool

Figure 42

Figure 43
ASSEMBLY
3. Attach the drift cutters with the screws and wing knobs on the outside of the
auger housing as shown in Figure 44.
Tire Pressure (If Applicable)
Under any circumstance do not exceed manufacturer's recommended psi.
Equal tire pressure should be maintained at all times. Excessive pressure
when seating beads may cause tire/rim assembly to burst with force
sufficient to cause serious injury. Refer to sidewall of tire for recommended
pressure.
The tires are over-inflated for shipping purposes. Check the tire pressure before
operating the snow thrower. Refer to the tire side wall for tire manufacturer's
recommended psi and deflate (or inflate) the tires as necessary.
NOTE: Equal tire pressure is to be maintained at all times for performance purposes.
Adjustments
Skid Shoes
The snow thrower skid shoes are adjusted at the factory to be approx 1/8" below
the bottom surface of the shave plate. Adjust them downward, if desired, prior to
operating the snow thrower.
It is not recommended that you operate this snow thrower on gravel as
it can easily pick up and throw loose gravel, causing personal injury or
damage to the snow thrower and surrounding property.
• For close snow removal on a smooth surface, raise skid shoes higher on the
auger housing. Refer to Figure 45.
• Use a middle or lower position when the area to be cleared is uneven, such as
a gravel driveway.
NOTE: If you choose to operate the snow thrower on a gravel surface, keep
the skid shoes in position for maximum clearance between the ground and
the shave plate.
19
Figure 44
WARNING
CAUTION