Wireless Mac Filtering - TP-Link PHAROS SERIES User Manual

SSID
Security Mode

Wireless MAC Filtering

Wireless MAC Filtering function uses MAC addresses to determine whether one host can access the
wireless network or not. Thereby it can effectively control the user access in the wireless network. This
function is available in all modes except the client mode.
Wireless MAC Filtering
3. Set the VLAN ID of wireless network identified by this SSID, and the value
ranges from 1 to 4094.
4. Select whether to broadcast this SSID or not.
5. Enable AP Isolation, the device would isolate the hosts within the same
wireless network. All the hosts cannot communicate with each other. The
default setting is Disable.
Select the added SSID to configure its security mode.
If all the hosts are allowed to access the wireless network, please select None.
For the safety of wireless network, you are suggested to encrypt your wireless
network. This device provides three security modes: WPA-PSK (Pre-Shared Key),
WPA (Wi-Fi Protected Access) and WEP (Wired Equivalent Privacy). WPA-PSK is
recommended. Please refer to Security Mode in the Wireless AP Settings section
for further information.
Check the Enable box to use wireless MAC filtering function.
1. Click Add in the table of wireless MAC filtering.
2. Select the wireless network (SSID) that you need to filter. In AP mode, if
Multi-SSID is enabled, you should set different filtering rules for each
SSID.
3. Enter the MAC address of the wireless host that you need to filter.
4. Enter the description information of this filtering rule in the Comment
filed.
- 65 -
Chapter 6 Wireless Tab