Understanding Built-In Cd Player Error Messages - Pioneer DEH-3400 Operation Manual

Additional Information
Understanding built-in CD player
error messages
When problems occur during CD play an error
message may appear on the display. If an error
message appears on the display refer to the
table below to see what the problem is and the
suggested method of correcting the problem. If
the error cannot be corrected, contact your
dealer or your nearest Pioneer Service Center.
Message Cause
ERROR-11, 12, Dirty disc
17, 30
ERROR-11, 12, Scratched disc
17, 30
ERROR-14 Blank disc
ERROR-10, 11, Electrical or
12, 14, 17, 30, mechanical
A0
HEAT CD player over-
heated
17 En
Action
Clean disc.
Replace disc.
Check the disc.
Turn the ignition
ON and OFF, or
switch to a
different source,
then back to the
CD player.
Turn off the CD
player until the
CD player cools
down.