Power On/Off; Charging - Zte C S265 User Manual

Connect the data cable to your phone
Plug the smaller end of the cable into the USB connection jack at one side of the phone, and the bigger
end into the USB port of the computer.
Tie a wrist strap with your phone
Thread a strap and tighten it.

Power on/off

Notes:
Do not power on your phone if wireless phone use is unapproved, or when it may cause interference or
danger.
1. Press and hold End Key to turn the phone on
Tips:
When being asked, enter your PIN (Personal Identification Number) code or phone code and press the
OK Key to confirm.
The PIN code is the password provided by your network service provider. You need this password to
use the UIM card.
When the entered PIN code or phone code is accepted, the phone will automatically search for the
designated network. After a few seconds, your phone will show the standby mode.
2. To power off the phone, press and hold the End Key from the standby mode.

Charging

Your phone is powered by a rechargeable battery. The battery is not fully charged when first unpacked,
but there may be enough power to power your phone on. You should use it up completely before charging
the battery for the first time. Charge the battery with the procedure indicated below.
1. Push down the USB port cover.
2. Insert the charger's USB adapter into the USB port.
3. Connect the charger to a standard AC wall outlet.
4. Remove the charger from both the wall outlet and the phone once the charging completed.
6 Confidential and Proprietary Information of ZTE CORPORATION