ProCurve 8200zl Series Management And Configuration Manual page 201

ProCurve(config)# show sntp
SNTP Configuration
Time Sync Mode: Sntp
SNTP Mode : Unicast
Poll Interval (sec) [720] : 719
Priority SNTP Server Address
-------- ---------------------------------------------- ----------------
1 2001:db8::215:60ff:fe79:8980
2 10.255.5.24
3 fe80::123%vlan10
Figure 9-4. Example of SNTP Configuration When SNTP Is the Selected Time Synchronization Method
ProCurve(config)# show sntp
SNTP Configuration
Time Sync Mode: Timep
SNTP Mode : Unicast
Poll Interval (sec) [720] : 719
Priority SNTP Server Address
-------- ---------------------------------------------- ----------------
1 2001:db8::215:60ff:fe79:8980
2 10.255.5.24
3 fe80::123%vlan10
Figure 9-5. Example of SNTP Configuration When SNTP Is Not the Selected Time Synchronization Method
In the factory-default configuration (where TimeP is the selected time
synchronization method),
though it is not currently in use. For example:
Syntax: show management
This command can help you to easily examine and compare
the IP addressing on the switch. It lists the IP addresses for
all time servers configured on the switch, plus the IP addresses
and default gateway for all VLANs configured on the switch.
SNTP: Viewing, Selecting, and Configuring
show sntp still lists the SNTP configuration even
Even though, in this example, TimeP is the
current time synchronous method, the
switch maintains the SNTP configuration.
Time Protocols
Protocol Version
7
3
3
Protocol Version
7
3
3
9-9