Enabling And Disabling Parksense; Service The Parksense Rear Park Assist System - Dodge Challenger 2018 Owner's Manual

Enabling And Disabling ParkSense

ParkSense can be enabled and disabled with the ParkSense
switch, located on the switch panel below the Uconnect
display.
ParkSense Switch
When the ParkSense system is disabled, the
instrument cluster display will display the
"PARKSENSE OFF" message for approximately
five seconds. Refer to "Instrument Cluster Dis-
play" in "Getting To Know Your Instrument Panel" for
further information. When the gear selector is moved to
REVERSE and the system is disabled, the instrument
cluster display will feature the "PARKSENSE OFF" mes-
sage for as long as the vehicle is in REVERSE.
The ParkSense switch LED will be on when ParkSense is
disabled or defective. The ParkSense switch LED will be off
when the system is enabled. If the ParkSense switch is
pushed and the system is disabled or requires service, the
ParkSense switch LED will blink momentarily and then the
LED will be on.

Service The ParkSense Rear Park Assist System

During vehicle start up, when the ParkSense Rear Park
Assist System has detected a faulted condition, the instru-
ment cluster will actuate a single chime, once per ignition
cycle and it will display the "PARKSENSE UNAVAILABLE
WIPE REAR SENSORS" or "PARKSENSE UNAVAILABLE
SERVICE REQUIRED" message for five seconds. Refer to
"Instrument Cluster Display" in "Getting To Know Your
Instrument Panel" for further information.
When the gear selector is moved to REVERSE and the
system has detected a faulted condition, the instrument
cluster display will display the "PARKSENSE UNAVAIL-
ABLE WIPE REAR SENSORS" or "PARKSENSE UN-
AVAILABLE SERVICE REQUIRED" message for as long as
the vehicle is in REVERSE. Under this condition, ParkSense
will not operate.
STARTING AND OPERATING 247
6