Operating Time Counter (Styling P3.0 Only); Reading The Operating Time; Display Of Total Operating Time - Electrolux EWX13611 Service Manual

8 OPERATING TIME COUNTER (styling P3.0 only)

Using a specific procedure, the operator can display the total operating time for the appliance, which is counted
from the moment it is first switched on.
The unit can count up to a maximum of 6,550 hours of operating time.
Only the operating time of normal programmes (and not diagnostic cycles) is counted.
The actual operating time for the cycle is counted (which does not include pauses, delayed start time, rinse
hold time and soaking phases).
 The precision of the counter is 30 seconds per programme.
 Only whole hours of operation are counted (1hr and 59 min. = 1 hr).

Reading the operating time

8.1
The operations listed below must be carried out within 7 seconds.
Switch on the appliance using the ON/OFF button
Use sensor S1 to select the position which lights up the fifth LED.
Simultaneously press the START/PAUSE button and the nearest option sensor (as shown in the diagram).
Keep your fingers over the sensors until the hours of operation appear on the display (at least 5 seconds).

Display of total operating time

8.2
This time is displayed with a sequence of two digits at a time: the first two digits indicate thousands and
hundreds, the second two digits indicate tens and units.
For example, if the operating time is 6,550 hours, the display will show the following sequence:
For two seconds
It displays: Hr
At the end of phase three (after the tens and units are displayed), the cycle is repeated.
To return to normal mode, either: switch off the appliance, press a key.
Technical Support - MDM
S1
Phase 1
For two seconds, the
following digits are displayed:
 thousands (6)
 hundreds (5).
Phase 2
31/104
Phase 3
For the next two seconds the
following digits are displayed:
 tens (5)
 units (0).
599 77 39-16 Rev. 00