14.3.4 Front panel
Remove the worktop (see relevant paragraph).
Remove the iron ring, remove the door bellow seal from the front panel.
Release the door safety device (see relevant paragraph).
Tilt the washing machine towards the back.
Unfasten the three screws securing the front panel at the bottom.
Raise the lower part a little without removing it entirely.
Pull out the detergent dispenser (see relative paragraph).
Remove the two screws securing the detergent dispenser to the control panel.
Loosen the screws which secure the dispenser to the crosspiece.
Loosen the screws which secure the front panel to the crosspiece.
Remove the four screws which secure the crosspiece to the rear cabinet.
Remove the clamp that secures the wiring.
Remove the wiring connector connecting the display board.
Remove the crosspiece.
To remove the front panel, first lift it up
and then pull it out of its supports.
Take care not to warp the screw seats,
because reassembly will be difficult if
they are warped.
81/104
Technical Support - MDM
599 77 39-16 Rev. 00