Sony XAV-W651BT Operating Instructions Manual page 41

English
Installing the navigation unit
Choose the installation location carefully so that the
unit will not interfere with normal driving operations.
Avoid installing the unit in areas subject to dust, dirt,
excessive vibration, or high temperature, such as in
direct sunlight or near heater ducts.
Use only the supplied mounting hardware for a safe
and secure installation.
Installation in the glove compartment
Before installation, clean the attachment surface.
1
Select a location in the glove compartment that
allows easy insertion/ejection of the map data
memory to/from the unit .
2
Attach the hook fasteners to the bottom of the
unit, and the loop fasteners to the position
where the unit is to be installed, then install the
unit .
Notes
Check that the unit is securely fixed.
Make sure the cords are not pinched by any part of the glove
compartment when it is being opened or closed.
Installing the GPS antenna (aerial)
Choose a location where no obstacle blocks GPS
satellite reception so as to achieve best reception.
Make sure the GPS antenna (aerial) does not
interfere with the operation of car equipment.
Some types of front windshield (windscreen) block
GPS satellite radio waves. If reception is poor when
the GPS antenna (aerial) is installed inside the car,
install it outside.
1
Decide the installation location on the dashboard
or rear tray, then clean the attachment surface.
Choose a flat surface where:
– the GPS antenna (aerial) can be positioned
horizontally.
– operation of the passenger-side airbag is not
impeded.
– GPS satellite reception is not blocked by anything
inside the car or the windshield (windscreen)
wipers.
2
Attach the mounting sheet , then attach the
GPS antenna (aerial) on it.
Notes
Be sure to use the mounting sheet , otherwise signal reception
may be poor.
Do not install the GPS antenna (aerial) close to other electrical
equipment, otherwise signal reception may be unstable.
If the surface of the mounting sheet is cold, the double-sided
tape may not stick firmly. Warm up its surface with a hair dryer, etc.,
before applying the tape.
If there is no flat surface on which to install the GPS antenna (aerial)
, bend the mounting sheet to fit a curved surface before
installing.
Performing the initial settings
When starting up the navigation module for the first
time, the initial setting display appears on the car
audio unit (AV Receiver).
1
Touch [Language] to set the display language,
then select the desired language.
2
Touch [Keyboard] to set the language when the
screen keyboard is touched, then select the
desired language.
3
Touch [Time] to set the time zone, then select the
desired time zone setting.
4
To go to the navigation display, touch [ System].
The following setup items can be also selected:
– [Version] displays the current software version.
– [Reset system settings] erases the clock setting and
some stored contents.
– [Open source licenses] displays the open source
licenses (licences).
Using the navigation function
Operate the car audio unit (AV Receiver) to use the
navigation function.
To select the navigation function
1
Press HOME, then touch [Navigation].
For further details on navigation operation, visit the
support site and refer to the manual provided.
Notes
During navigation operation, USB video is not available.
Navigation operation cannot be performed by the remote
commander.
Voice guidance may be output only from the front speakers
depending on the car audio unit (AV Receiver). For details, refer to
the manual supplied with the car audio unit (AV Receiver).
To switch to the current background source
Press SOURCE repeatedly until the desired source
(Audio playback, Tuner, AUX) appears.
This operation differs depending on the car audio unit
(AV Receiver). For details, refer to the manual supplied
with the car audio unit (AV Receiver).
Specifications
Power requirements:
12 V DC car battery (negative ground (earth))
Rated current consumption:
1 A
Dimensions (unit) ( ):
Approx. 140 mm × 75.6 mm × 27 mm
(5 / in × 3 in × 1 / in) (w/h/d)
5 1
8 8
Mass: Approx. 220 g (8 oz)
Operating temperature:
5 °C to 45 °C (41 °F to 113 °F)
Package contents:
Navigation unit (1)
Map data memory (1)
Hook and loop fastener (2)
Power connection cable (1)
Control cable (1)
GPS antenna (aerial) (1)
Mounting sheet (1)
Design and specifications are subject to change
without notice.
Troubleshooting
The navigation function does not work properly.
The power connection of the navigation unit is not
made properly.
– Check that the power connection cable is
connected to the navigation unit properly.
The navigation unit and the car audio unit (AV
Receiver) are not connected properly.
– Check that the navigation unit and the car audio
unit (AV Receiver) are connected with the control
cable securely.
Turn off the ignition and wait for about 10 seconds,
then turn on the ignition again.
The current position of your car is not displayed on
the map properly.
The GPS antenna (aerial) may be connected
incorrectly.
– Check that the GPS antenna (aerial) is securely
connected.
The location of the GPS antenna (aerial) may be
inappropriate.
– Change the location of the GPS antenna (aerial).
"No Maps Available" is displayed.
The map data memory may not be inserted, or may
be inserted incorrectly.
– Insert the map data memory correctly.
The clock time is not accurate.
The GPS antenna (aerial) may be connected
incorrectly.
– Check that the GPS antenna (aerial) is securely
connected.
The location of the GPS antenna (aerial) may be
inappropriate.
– Change the location of the GPS antenna (aerial).
The time zone setting may be inappropriate.
– Check that the setting of the time zone matches
your area from the setup menu.
Touch [Menu] [ (setting)] [System]
[Time].
The map data memory is not the latest.
For details on the latest map data memory, visit the
support site.
The voice guidance of the navigation function is not
heard.
The volume of the navigation unit and the car audio
unit (AV Receiver) may be too low.
– Increase the volume of the navigation unit and
the car audio unit (AV Receiver) moderately.
The volume of the car audio unit (AV Receiver)
can be adjusted only while the voice guidance is
provided.
Support site
If you have any questions or for the latest support
information on this product, please visit the website
below:
Customers in the United States/Canada:
http://esupport.sony.com/
Customers in Europe:
http://www.sony.eu/support
Customers in Asia Pacific:
http://www.sony-asia.com/section/support
http://www.sony-asia.com/caraudio/
http://www.sony.com/caraudio