Boot Commands - Cisco TelePresence SX80 Reference Manual

Cisco TelePresence SX80
Contents Introduction

Boot commands

xCommand Boot
Reboot system.
Action: As a default the system restarts after a reboot. By selecting Shutdown, the system will not
restart.
Requires user role: USER
Parameters:
Action: <Restart/Shutdown>
Example:
xCommand Boot
*r BootResult (status=OK):
** end
OK
CUIL reboot request, restarting
Connection closed by foreign host.
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration
Call commands
xCommand Call Accept
xCommand Call Disconnect
xCommand Call DisconnectAll
99
xCommand xCommand
Accept an incoming call. If no CallId is specified, all incoming calls are accepted. The CallID is
returned when the xCommand Dial command is run. During the call you can run the xStatus Call
command to see the CallId. CallType parameter is not in use.
Requires user role: USER
Parameters:
CallId: <0..65534>
CallType: <Audio/Video> Not in use.
Example:
xCommand Call Accept CallId:19
Disconnect a call. The CallID is returned when the xCommand Dial command is run. During the call
you can run the xStatus Call command to see the CallId.
Requires user role: USER
Parameters:
CallId(r): <0..65534>
Example:
xCommand Call Disconnect CallId:17
Disconnect all active calls.
Requires user role: USER
Example:
xCommand Call DisconnectAll
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.