Cisco TelePresence SX80 Reference Manual page 39

Cisco TelePresence SX80
Contents Introduction
xConfiguration Cameras Camera [1..7] Gamma Level
By setting the Gamma Level you can select which gamma correction table to use. This setting may
be useful in difficult lighting conditions, where changes to the brightness setting does not provide
satisfactory results. Requires the Gamma Mode to be set to Manual.
Requires user role: ADMIN
Value space: <0..7>
Range: Select a value between 0 and 7.
Example: xConfiguration Cameras Camera 1 Gamma Level: 0
xConfiguration Cameras Camera [1..7] IrSensor
Not applicable in this version.
xConfiguration Cameras Camera [1..7] Mirror
With Mirror mode (horizontal flip) you can mirror the image on screen. Mirroring applies both to the
self-view and the video that is transmitted to the far end.
Requires user role: ADMIN
Value space: <Auto/Off/On>
Auto: If the camera detects that it is mounted upside down, the image is automatically mirrored.
If the camera cannot auto-detect whether it is mounted upside down or not, the image is not
changed.
Off: Display the image as other people see you.
On: Display the image as you see yourself in a mirror.
Example: xConfiguration Cameras Camera 1 Mirror: Auto
xConfiguration Cameras Camera [1..7] MotorMoveDetection
This setting applies only when using a Cisco TelePresence PrecisionHD 1080p12x camera.
If adjusting the camera position by hand you can configure whether the camera should keep its new
position or return to the preset or position it had before.
Requires user role: ADMIN
Value space: <Off/On>
Off: When the camera position is adjusted manually the camera will keep this position until
adjusted again. WARNING: If moving the camera by hand, the camera will not register the new
pan and tilt values since there is no position feedback. This will result in wrong pan and tilt values
when recalling the camera presets subsequently.
On: When the camera position is adjusted manually, or the camera detects that the motors have
moved, it will first re-initialize (i.e. go to default position) then return to the preset/position it had
before the camera was adjusted.
Example: xConfiguration Cameras Camera 1 MotorMoveDetection: Off
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
D15107.05
About the API xConfiguration xConfiguration
xConfiguration Cameras Camera [1..7] Whitebalance Mode
xConfiguration Cameras Camera [1..7] Whitebalance Level
xConfiguration Cameras Camera [1..7] DHCP
39
xCommand
Set the camera white balance mode.
Requires user role: ADMIN
Value space: <Auto/Manual>
Auto: The camera will continuously adjust the white balance depending on the camera view.
Manual: Enables manual control of the camera white balance. The white balance level is set using
the Cameras Camera Whitebalance Level setting.
Example: xConfiguration Cameras Camera 1 Whitebalance Mode: Auto
Set the white balance level. Requires the Camera Whitebalance Mode to be set to manual.
Requires user role: ADMIN
Value space: <1..16>
Range: Select a value between 1 and 16.
Example: xConfiguration Cameras Camera 1 Whitebalance Level: 1
Not applicable for this product.
API Reference Guide
xStatus Appendices
Copyright © 2015 Cisco Systems, Inc. All rights reserved.